Special two-component primer formulated to give excellent adhesion on fiberglass surfaces. It is applied as a base coat on superstructures, sides or hulls of fiberglass boats. It can be applied directly on gelcoat after adequate degreasing of the surface with a suitable detergent and light sanding with fine abrasive paper.
0.00 Dhs
ComparePREPARATION OF THE SUPPORT AND APPLICATION CYCLE
Fiberglass and Plastic. The surface must be degreased with a suitable detergent, rinsed, lightly sanded with fine sandpaper and dusted. Apply a coat of POLIFIBER PRIMER, possibly followed by a second coat in the case of a very corrugated substrate. After 24 hours, sand with fine sandpaper and continue with the desired finishing cycle.
Thinner No.3 is suitable for antifouling paints (except for VC® products), bottom coatings and other special paints. It’s also used to help spray on our one-part varnishes and finishes.
This is a two component non shrinking solvent free epoxy filler. It is high strength, providing the abrasion
resistance and compressive strength higher than concrete. To be used as filler only. Suitable for properly
prepared concrete surfaces.
There are no reviews yet.